Finished setting default values for core params
#NETGEAR READYCLOUD HOW TO SETUP USB DRIVER#
usbcore: registered new interface driver cdc_ncm usbcore: registered new interface driver smsc95xx vcos: : vchiq: initialised - version 2 (min 2), device 252.0 vcos: : vchiq_init_state: slot_zero = 0xffd80000, is_master = 0 Console: switching to colour frame buffer device 160圆0 io scheduler deadline registered (default) FS-Cache: Netfs 'nfs' registered for caching Dquot-cache hash table entries: 1024 (orbytes) audit: initializing netlink socket (disabled) RPC: Registered tcp NFSv4.1 backchannel transport module. RPC: Registered named UNIX socket transport module. UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) UDP hash table entries: 256 (order: 0, 4096 bytes) TCP: Hash tables configured (established 16384 bind 16384) TCP bind hash table entries: 16384 (order: 4, 65536 bytes) TCP established hash table entries: 16384 (order: 5, 131072 bytes) IP route cache hash table entries: 4096 (order: 2, 16384 bytes) usbcore: registered new device driver usb usbcore: registered new interface driver hub usbcore: registered new interface driver usbfs mailbox: Broadcom VideoCore Mailbox driver hw-breakpoint: maximum watchpoint size is 4 bytes. hw-breakpoint: found 6 breakpoint and 1 watchpoint registers. hw perfevents: enabled with v6 PMU driver, 3 counters available sched_clock: 32 bits at 1000kHz, resolution 1000ns, wraps every 4294967ms Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) PID hash table entries: 2048 (order: 1, 8192 bytes) Built 1 zonelists in Zone order, mobility grouping on. Normal zone: 113792 pages, LIFO batch:31 free_area_init_node: node 0, pgdat c050db28, node_mem_map c05b6000 Memory policy: ECC disabled, Data cache writeback CPU: PIPT / VIPT nonaliasing data cache, VIPT nonaliasing instruction cache
CPU: ARMv6-compatible processor revision 7 (ARMv7), cr=00c5387d Wlan0 Link encap:Ethernet HWaddr c4:3d:c7:bc:34:db TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:7485 errors:0 dropped:0 overruns:0 carrier:0 RX packets:10096 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 When I tap on connect, i can see 'Failed to initiate AP Scan' message in the progress.įind output of lsusb, iwlist scan and ifconfig below. Though power seems to be not an issue anymore, I can scan for network and configure, but i was not able to connect to my network. However, I was not able to connect/configure wifi successfully. I managed to power my Netgear N150 directly with RPi native port by supplying 2A 5+V DC to RPi. After my failed attempt with DYI powered USB hub.
0 kommentar(er)
